are leaving VL on the breakout board unconnected. If you have never used the Arduino IDE before, this turoial should get you started. Make sure each gesture begins outside of the range of the sensor, moves into the range of the sensor, and ends outside the range of the sensor. 3.) Hook up your RGB Controller.
You made a simple gesture sensor, but where do you go from there? Gestures will appear on the serial monitor, which indicate the direction of the swipe. If you have not previously done so, install the ftdi drivers. adafruit Arduino - Lesson. We recommend never pushing any product to the maximum load but instead leave a 10-15 cushion as to not over drive and damage any of the product. Colors using internet colors This guide was first published on Nov 30, 2012.
RGB Panel Hookup Guide How to Hook Up RGB to Vizio How to Connect a PC to a, tV Using an RGB Cable